Magnum-dynalab MD-209 Manuel d'utilisateur

- 1 - Magnum Dynalab MD 209 HYBRID AUDIO RECEIVER INSTRUCTION MANUAL

- 10 - RC4 REMOTE CONTROL Unpacking the Remote: • Remove the remote from its plastic bag, and install the 2 “AA” batteries provided • Test the re

- 11 - IMAGE OF RC4 REMOTE

- 12 - CONTROL FUNCTIONS (Numbers correspond with product diagram on page 13) 1. POWER – Switches the power (AC) on and off to the receiver. 2. I

- 13 - 11. SIGNAL STRENGTH/MULTI-PATH DISPLAY – The readout of this meter is controlled by button 7, showcasing either incoming RF Signal Strength or

- 14 - TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION No sound, meter lights are not on Power cord disconnected Power off at source Fuse

- 15 - RECEPTION TECHNIQUES Antenna Cabling: The lead-in cable from the antenna is often the weakest link in the FM system. Some time spent on sele

- 16 - (generally provided with a tuner or receiver). This piece of wire is bi-directional and the performance of it is affected by the angle that th

- 17 - SPECIFICATIONS Power Audio Frequency Response (+/-0.1dB) Class of Operation Harmonic Distortion Gain Control Signal to Noise Ratio Total Harm

- 18 -

- 19 - SAFETY SHEET IMPORTANT SAFETY INSTRUCTIONS 1. KEEP THESE INSTRUCTIONS 2. HEED ALL WARNINGS 3. FOLLOW ALL INSTRUCTIONS 4. DO NOT USE TH

- 2 - TABLE OF CONTENTS DEAR VALUED CUSTOMER ... 3 UNPACKI

- 20 - LIMITED WARRANTY Register your product at www.magnumdynalab.com Magnum Dynalab Ltd. herein referred to as the “manufacturer” guarantees thi

- 21 - COVER OR FACEPLATE, NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

- 3 - Dear Valued Customer Thank you for choosing the Magnum Dynalab MD 209 Hybrid Audio Receiver. Great care has been given to the design, manufact

- 4 - UNPACKING YOUR MD 209 HYBRID AUDIO RECEIVER Carefully inspect all sides of the shipping carton for damage. If there are marks or holes in the

- 5 - SETTING UP THE MD 209 HYBRID AUDIO RECEIVER 1. Position the receiver away from any spot which may have extremes in temperatures. 2. Place

- 6 - SET UP OF THE INTEGRATED AMPLIFIER SECTION OF THE MD 209 HYBRID AUDIO RECEIVER (All numbers correspond to the product diagram on Page 13) CAUT

- 7 - Press the Stereo button again and this will switch to Mono – the stereo light should go out. 7. If you hear a crackling sound push the Multi

- 8 - SET UP THE MD 209 HYRBID AUDIO RECEIVER WITH AN EXTERNAL HOME THEATER PROCESSOR The MD 209 Hybrid Audio Receiver is equipped with a unity gain

- 9 - HOOKING UP A SUBWOOFER TO YOUR SYSTEM 1. Unplug the power to the MD 209 Hybrid Audio Receiver. 2. Using RCA cables, connect one end to the