Magnum-dynalab MD-106T Manuel d'utilisateur télécharger pdf (Page 4)

- 4 -

UNPACKING YOUR 106T

Carefully inspect all sides of the shipping carton for damage. If there are marks or

holes in the carton make note of the location in relation to the unit inside. Any

obvious dents or scuff marks should alert you to the possibility of damage.

Carefully remove the MD 106T from the end caps and wrapping, inspect all

sides. Pay special attention to the corresponding areas on the unit where damage

was found to the shipping carton. If damage is evident, document the type and

extent of the damage, then repack the unit and call the dealer.

KINDLY DO NOT SEND THE UNIT BACK TO THE SHIPPER UNTIL YOU HAVE BEEN

ASKED TO DO SO.

DO NOT DISCARD THE PACKING MATERIALS AND CARTONS. Should there be a

necessity to return the unit for any reason, it must arrive safely and suitably

packaged in order for our receiver to accept it from the carrier. Also, if the unit

has incurred damage as a result of improper packaging, it is not likely that a

claim for the damage against the carrier will be successful.

Likewise, we will ship your unit back to you only in factory-approved packaging,

However, if the unit were to arrive at the factory in anything other than factory

approved packaging, we reserve the right to return same in factory-approved

packaging and charge the cost of the packaging to the shipper. This is the only

way we can assure you of a safe return (damage by carrier excepted).

1 2 3 4 5 6 7 8 9 ... 15 16

Pas de commentaire

Magnum-dynalab MD-106T Manuel d'utilisateur Page 4